MOUNTS AND INTERFACES

REVOLUTION BIPOD MOUNTS AND REVOLUTION BIPOD INTERFACES

Every REVOLUTION BIPOD comes with a choice of one free mount. However, if you want to purchase an additional mount or interface for another rifle, you will need to choose the right mount and the interface for that rifle.

If your rifle has a interface such as a PIC RAIL, a interface might not be needed.

Take the following 3 steps to order your REVOLUTION BIPOD Mount

 STEP #1:

Your rifle’s PIC RAIL MOUNT OFFSET MUST BE MEASURED to select the correct MOUNT to match your rifle’s INTERFACE. If one of our standard mounts will not fit your rifle, a custom mount can be made for you by contacting ELITE IRON at 406-244-0234.

HOW TO MEASURE FOR PIC RAIL MOUNT OFFSET (Measurements must be in inches to the nearest thousandth.)

MEASUREMENT #1 from top of barrel to bottom of PIC RAIL MOUNT:

NOTE: Measurements must be included in “ORDER NOTES” in the CART to expedite processing of your order.

If 2.100” or less, select the below Standard Offset Mount.

If between 2.100” and 2.300”, select the below Medium Offset Mount.

If between 2.300” and 2.550”, select the below High Offset Mount.

If more than 2.550” from Measurement #1, a custom mount will be required.

MEASUREMENT #2 from the end of the PIC RAIL to the end of the stock:

If Measurement #2 is more than 0.500”, a custom mount will be required.

Have a McRees, SCAR 17S,  Savage BA110, Accuracy International or similar Rifle?

You must select the below Quick Connect PIC RAIL Mount.

Note: QUICK CONNECT PIC RAIL MOUNT must be used with QUICK CONNECT INTERFACE

STEP 3:  SELECT YOUR REVOLUTION BIPOD INTERFACE

The Interface on your rifle should match your chosen Mount.

Remember, if your rifle has an existing interface, a interface might not be needed, you must select No Interface in the pull down.

STEP 4:  After you choose your Mount and Interface, select them from the pull down menus below to put them in the cart.